Manual de instruções Sony XDR-S56DBP

    To reduce the risk of fire or electric shock, do not expose this apparatus to
    rain or moisture.
    To avoid electrical shock, do not open the cabinet. Refer servicing to
    qualified personnel only.
    Do not install the appliance in a confined space, such as a bookcase or built-in
    To reduce the risk of fire or electric shock, do not place objects filled with liquids,
    such as vases, on the apparatus.
    Connect the AC power adaptor to an easily accessible AC outlet. Should you
    notice an abnormality in the AC power adaptor, disconnect it from the AC outlet
    Excessive sound pressure from earphones and headphones can cause hearing loss.
    Do not expose the batteries (battery pack or batteries installed) to excessive heat
    such as sunshine, fire or the like for a long time.
    Batteries may leak if improperly installed.
    In case of battery leakage
    If the battery fluid has leaked, do not touch the fluid with your bare hands.
    Battery fluid may remain inside the unit. Consult your nearest Sony dealer.
    If battery liquid gets into your eyes, do not rub your eyes, as blindness may occur.
    Quickly wash your eyes with plenty of clean water and immediately seek medical
    If battery liquid gets on your body or clothing, burns or injury may occur. Quickly
    wash off with clean water, and seek medical attention if skin inflammation or
    injuries occur.
    Notice for customers: the following information is only applicable to
    equipment sold in countries applying EU directives
    The manufacturer of this product is Sony Corporation, 1-7-1 Konan, Minato-ku,
    Tokyo, 108-0075 Japan. The Authorized Representative for EMC and product
    safety is Sony Deutschland GmbH, Hedelfinger Strasse 61, 70327 Stuttgart,
    Germany. For any service or guarantee matters, please refer to the addresses given
    in separate service or guarantee documents.
    (Band-III) Digital Radio.
    Easy view, 2-line character dot LCD display.
    Simple operation for station selection.
    Three Direct preset station buttons.
    Sleep timer and clock display.
    Stereo headphone jack.
    Battery (LR6 × 4) or mains operated.
    Choosing power sources
    Installing batteries (See fig. )
    1 Open the battery compartment at the rear of the unit.
    2 Install four LR6 (size AA) alkaline batteries (not supplied),
    observing polarity, and then close the lid.
    Battery Life (Approx. hours) (JEITA*)
    When using DAB/DAB
    Sony alkaline LR6 (size AA) 13 13.5
    * Measured by JEITA (Japan Electronics and Information Technology Industries
    Association) standards. The actual battery life may vary depending on usage
    and circumstances.
    Knowing when to replace the batteries
    As the batteries become weak, the sound will become weak and distorted.
    When the batteries are completely exhausted, “
    ” appears in the display and the
    power is turned off.
    When “
    ” appears, replace all batteries with new ones. After the batteries are
    replaced, press POWER to turn the indication off.
    Notes on replacing the batteries
    Do not take more than about 1 minute to replace the batteries, otherwise the
    clock, any lists of receivable broadcasts for DAB scan, preset favourite services
    and all settings will be initialized. Should that happen, these functions will need
    to be set again.
    If the batteries are replaced while the power is on, the unit may revert to the
    factory setting.
    Notes on batteries
    Do not attempt to recharge dry batteries.
    Do not carry batteries with coins or other metallic objects. It can generate heat if
    the positive and negative terminals of the batteries are accidentally shorted by a
    metallic object.
    If you are not going to use the unit for a long time, remove the batteries to avoid
    damage from battery leakage and corrosion.
    Do not use different types of batteries at the same time.
    When you replace the batteries, replace all with new ones.
    If the battery compartment lid comes off
    (See fig. )
    The battery compartment lid is designed to come off when opened with excessive
    force. To reattach it, do the following. (Refer also to the illustration.)
    Insert the right hinge of the lid into the right hole of the unit.
    Insert the left hinge into the left hole of the unit.
    Using house current (See fig. )
    Connect the AC power adaptor (supplied) to the DC IN 6 V jack firmly, and plug
    it into a wall outlet.
    Notes on the AC power adaptor
    When operating the unit with the internal batteries, remove the AC power
    adaptor from the wall outlet and the DC IN 6 V jack. Make sure that the plug of
    the external power source is disconnected before operating the unit.
    Use the supplied Sony AC power adaptor only. The polarity of the plugs of other
    manufacturers may be different. Failure to use the supplied AC power adaptor
    may cause the unit to malfunction.
    Improving the reception
    (See fig. )
    DAB Band-III/FM:
    Extend the telescopic aerial and adjust the length and the angle for best reception.
    Adjust the direction of the aerial by holding it at the bottom.
    The aerial can be damaged if you move the aerial with
    excessive force.
    Initial setting for the DAB
    When the batteries are installed, or when the AC power adaptor is plugged in for
    the first time after purchase (or after resetting), pressing the POWER button on
    the unit will scan and create a list of receivable broadcasts
    If you wish to scan for DAB broadcasts again, or when the unit is reset, do the
    1 Adjust the aerial accordingly.
    2 Press POWER to turn on the radio.
    3 Hold down AUTO TUNE for more than 2 seconds.
      
    ” appears in the display.
    4 Press PRESET/ENTER.
    No sound will be heard, and “
    ” appears in the display. DAB scan
    takes about 30 ~ 90 seconds. When finished, the unit receives the first service
    in alphabetical order stored by the DAB scan.
    If you do not operate within 65 seconds, the initial scan mode will be cancelled.
    If no broadcasts are found by the DAB scan, “
      
    ” will be
    To cancel the DAB scan halfway, press
    AUTO TUNE. Any services received
    before cancellation are added to the list of receivable services.
    If the batteries are removed for a certain period, the received history list will be
    deleted, requiring you to scan again.
    Initialization will erase any DAB services registered as
    If you change the units location of use, or want to add a new service after initial
    setting, press and release AUTO TUNE. “
     
    ” appears in the
    display and the unit will automatically scan and create a list of receivable services.
    DAB or DAB
    may not be receivable, depending on the country/region in which
    this unit is used.
    DAB/FM Digital
    Operating Instructions
    DAB broadcasts with poor quality reception may be selected when Auto scan is
    performed. In this case, perform Manual tune, which may improve reception.
    Setting the clock
    For the first time after purchase, or after resetting, “AM 12:00” (or “0:00”) will
    blink in the display when batteries are installed or the AC power adaptor is
    plugged in, and then POWER is pressed.
    1 Hold down CLOCK for more than 2 seconds to show the time set
    2 Turn
    (down) to select “
    ” and press PRESET/ENTER.
    The hour indication starts blinking.
    Example: 12-hour system.
    3 Turn
    (down) to set the hour, and then press PRESET/
    The minute indication starts blinking.
    4 Turn
    (down) to set the minute, then press PRESET/
    The clock starts operating, and “
    ” starts blinking.
    To set the current time rapidly, hold
    To set the current time exactly to the second, adjust the minute function in step
    4 and then press PRESET/ENTER together with a time signal (such as the
    telephone time signal).
    The clock system varies depending on the model purchased. For example, in the
    24-hour system, midnight is indicated by “0:00”, and noon is indicated by
    If you halt clock setting for over 65 seconds, the clock setting mode will be
    To cancel the clock setting mode halfway, press
    To show the current time as DAB is received, press
    (See “Changing the display”).
    Setting the clock auto adjustment function
    This function enables the built-in clock of this unit to automatically synchronize
    with any DAB data being received.
    1 Hold down CLOCK for more than 2 seconds to show the time set
    2 Turn
    (down) to select “
    ” and press PRESET/ENTER.
    CLOCK ADJ ” lights and DAB data adjusts the clock as it is received.
    If DAB is not available (depending on area), you can disable this function.
    If this function is active while adjusting the clock manually, DAB data will
    adjust the clock the next time it is received.
    Operating the radio
    The unit can receive DAB services and FM stations, both of which feature
    PRESET and MANUAL modes - DAB services also feature ALPHABETICAL
    ALPHABETICAL: To select a stored service in alphabetically.
    PRESET: To select preset services. “P ” appears in the display.
    MANUAL: To adjust the frequency incrementally.
    1 Press POWER to turn on the radio.
    The last band you listened to is received.
    2 Press •DAB/FM SC repeatedly to select the desired band.
    Each press changes the band as follows:
    3 Press TUNE MODE to select the desired mode.
    4 Turn
    to tune to the desired service or station.
    Two short beeps sound when the lowest ensemble of DAB or the minimum
    frequency of FM is received during tuning.
    5 Adjust the volume using VOLUME.
    Notes in FM usage
    The FM channel incremental step is 0.05 MHz.
    When an FM stereo broadcast is received, “
    ” is displayed.
    Notes in DAB usage
    Before receiving DAB broadcasts, one or more ensembles should be stored in
    the list by the DAB scan. (See “Initial setting for the DAB”).
    If there are no services, only
    MANUAL mode is available.
     
    ” is displayed if the ensemble for the selected service cannot
    be received.
    If a selected service finishes broadcasting, sound stops and “
     
    appears. In this case, turn
    to select another service.
    About the SC (Secondary Component)
    If the selected primary component has a secondary component, “SC ” blinks in
    the display.
    Press •DAB/FM SC for more than 2 seconds to receive the desired secondary
    component. “SC ” appears while the secondary component is received.
    or pressing •DAB/FM SC does the following:
    When the selected secondary component is finished, the unit returns
    automatically to the primary component.
    Receiving DAB broadcast services by MANUAL
    1 Press •DAB/FM SC repeatedly to select DAB.
    2 Hold down TUNE MODE for more than 2 seconds.
    ” appears in the display.
    3 Turn
    to tune to the desired DAB channel.
    When a DAB broadcast can be received, the display indication changes from
    the frequency to the component label, and sound will be heard.
    The new DAB broadcast received by
    MANUAL mode is added to the list of
    receivable services.
    To exit
    MANUAL mode, press TUNE MODE. “
    ” turns off in the display.
    PRESET 1, 2, 3
    DC IN 6V
    Insert the side of the
    battery first.
    LR6 (size AA) × 4
    AC power adaptor
    DC IN 6V
    RESET button
    ©2011 Sony Corporation Printed in China

Precisa de ajuda?

Número de perguntas: 0

Você tem alguma dúvida sobre o Sony XDR-S56DBP ou precisa de ajuda? Faça sua pergunta aqui. Forneça uma descrição clara e abrangente do problema e sua pergunta. Quanto mais detalhes você fornecer para seu problema e pergunta, mais fácil será para outros proprietários de Sony XDR-S56DBP responderem adequadamente à sua pergunta.

Veja o manual do Sony XDR-S56DBP aqui, de graça. Este manual está na categoria Rádios e foi avaliado por 1 pessoas com uma média de 7.5. Este manual está disponível nos seguintes idiomas: Inglês. Você tem alguma dúvida sobre o Sony XDR-S56DBP ou precisa de ajuda? Faça a sua pergunta aqui

Sony XDR-S56DBP especificações

Marca Sony
Modelo XDR-S56DBP
Produto Rádio
EAN 4905524731149
Língua Inglês
Tipo de arquivo PDF
Tipo de rádio Pessoal
Tipo de sintonizador Digital
Bandas do Rádio DAB, DAB+, FM
Sintetizador PLL -
Quantidade de estações predefinidas 3
Classificação de Energia RMS 0.3
Altifalantes incorporados
Número de altifalantes incorporados 1
Diâmetro do altifalante 77
Visor incorporado
Cor da retroiluminação Âmbar
Saída de auscultadores 1
Entrada para auscultadores 3.5 mm
Playback MP3
Cor do produto Preto
Controlo do volume -
Outras características
Compatibilidade com base Apple Não suportado
LED de indicação de energia
Temporizador de sono
Pesos e dimensões
Comprimento 189
Largura 37.9
Altura 102.8
Peso do produto 486

Perguntas Frequentes

Abaixo, encontrará as perguntas mais frequentes sobre Sony XDR-S56DBP .

A sua pergunta não está na lista? Faça a sua pergunta aqui

Procurando um manual? garante que encontrará o manual que está a procurar rapidamente. O nosso banco de dados contém mais de 1 milhão de manuais em PDF de mais de 10.000 marcas. Todos os dias adicionamos os manuais mais recentes para que sempre encontre o produto que procura. É muito simples: basta digitar o nome da marca e o tipo de produto na barra de pesquisa e pode visualizar instantaneamente o manual de sua escolha online gratuitamente.

© Copyright 2020 Todos os direitos reservados.

Utilizamos cookies para assegurar que lhe fornecemos a melhor experiência na nossa página web. Se continuar a utilizar esta página pressupomos que está feliz por a utilizar.

Ler mais